Recent content by ahha0527

it says “fault ignition control” havent checked it yet..wantes to get some input meanwhile

*hear the ignitor

ignitor is good blower only blows for about 5-10 seconds..doesnt even get to the ignition phase where you heater the ignitor..it turns off before that

Hello Blower starts and stays on for about 5-10 seconds then turns off..is not able to stay on for the ignition phase then “fault ignition control” comes out was working fine before

thank you for reply so im guessing relay is just for one speeds?

thank you for your reply which are the line screws? yes i believe it is

this is the relay is this the power your refering to? thanks for your reply

connected wth normal L1, L2 wiring from pump to pool panel turns on via iaqualink app and when put on service mode/filter pumo i believe i hear the relay click ahen activated but the pump doesnt stay on longer than 30 seconds

230V

and pump fills with water

Hello Brand new E Pro installed pump turns on and stays on for about 30 seconds to 1 minute then it turns off ..then will turn on again after about 10 seconds and cycle repeats anyone have any idea why the pump is doing this? jandy rs panel / iaqualink

maybe the filter pump is done?:( just want to make sure there might be other issue before replacing pump

yes - tried both auto mode with filter pump activated and service mode with filter pump on both give same results shown in video breakers are on there is power going in panel and power going to filter pump but filter pump doesnt turn on nothing else was changed it was simple plug everything...

Hello recently jandy rs insterface was switched out pretty straight forward - all cables were connected to new interface just as it was in old one the filter pump is the only one that doesnt turn on there is power going to pump but nothing any suggestions? i attached video of what happens...