Recent content by adam.engel01

Wow. How I didn’t figure that out I do not know. 😂 I’m assuming I won’t be able to adjust temp this way or will I?

Hey all. I have an older aquacal heat pump. I followed the directions in the manual and called aquacal also. They had me run my low voltage wire to y and z terminals in the heater then run the other end to the intellicenter obviously. I then hit the up down button on the heater til the program...

So I finally got around to doing this but apparently I have the 4 button heat pump not the 5. This is the manual but I see nothing about being able to control it through the intellicenter...

Awesome. Thanks! That will save me a ton of $$$

It isn’t hooked up to the pool yet but I ran a wire from my panel to check it all. I did not look for anything on that portion. Here is a picture of the board. Hard to see what’s going on but I hope that helps.

The ou the outdoor unit seems to be fine. Not sure how to tell if the egg board powers up.the screen on the intellicenter does power up.

What is the difference between the pn you said vs 523596?

This was install I got it second hand and obviously don’t know what I’m doing. 😂 I’m learning as I go I guess. Trying to upgrade my current system

Hey all, You guys have been a wealth of knowledge so far and as much research as I have done I once again need some help. I got a pentair intellicenter. I have the outdoor WiFi egg but I don’t have the inside box and since I see the numbers need to match I’m assuming I need to buy a whole new...

Awesome. This is what I was hoping. I don’t have it on my other salt water pool.

Hey all I have a leak in one of my fittings and I’m going to fix it but what is this hanging off the bottom of the plumbing and why is it bonded? Do I need it?

Thank you! This is extremely helpful.

It is aquacal. Slide 5 button display. I keep trying to research this but keep coming up empty handed.

The heater is an electric heat wave super quiet. This was taken off a house that had a gas heater. In the picture you can see they had one of the relays labeled heater. Do I need to go from the breaker to the relay? Or just run the control wire from the heater straight to the gas heater plug?