Recent content by aaronc1976

Yeah, stupid me. I had opened it up saw them all plugged in and assumed installers plugged them into their correct spots. You know what assume means though lol. Thanks again!

Yes I do understand all that just did not know how to do all the testing. Again, sorry for being dumb. At any rate, I ran the test and at first, remained at 1 so for Darns and giggles I tested all unused relays, aux 3, ,5, 6 and 7 also measured at 1. I traced all relay wires to the low...

I apologize for my ignorance and thanks again for all the help you freely provide. Just to be clear, I pull the wires out of both line and load and measure as I click the Aux 5 button or do I leave load line plugged into screw? Again, truly sorry for my stupidity.

Ok, so I tied all neutrals together and removed extra neutral wire from neutral bus bar. I'm still not getting any voltage. I'm attaching pics of panel, the relay plugs, the junction box and the transformer enclosure. To run resistance test, I set to 200 Ohms just to the left of the diode...

I will get a wire diagram and some pics for you tomorrow.

One other thing I am thinking of. I think I may have screwed up. See if you can follow. I have line from transformer and line from fire pit come into a junction box. Ground wires are nutted together and brought into the sub panel to the ground bus bar. But, I brought two separate neutral...

Here is a picture of multimeter. Do you mind teaching me how to do a continuity test between line and load on Aux 5? I'm really sorry to ask. I had one before but never used it. I somehow dropped it a while ago and it doesn't turn on. This one I just picked up from Harbor Freight. Do I...

Attached is wiring diagram on inside of enclosure. I'm not seeing what you are saying. It is showing normal high voltage in, low voltage out.

Ok, so I tested and there is 120 V on terminal 1 but nothing on the load terminal when I activate the Aux 5 . Bad connection at the terminal possibly or do you think installers mixed up when plugging in the relays on the low voltage side? What should I check next?