Recent content by 77shovelhead

No luck finding Jacuzzi parts so I opted for a new filter setup. Family Leasure has a eco Kleer 22" with 1.5 motor. The only problem I see so far is that, eco kleer recomends that the filter be placed no more than 5 feet from the pool. My old filter is 23 feet from the skimmer and 21 feet from...

I have a crack at the pressure gauge port and water running down the side of the multi port valve on my filter. I can try finding another multiport or replace the whole filter. Because Jacuzzi 190L parts are getting rare, I'm thinking a new filter is in order. If I can not find a new valve, how...

Well the temps were right this weekend for changing the liner and most all went well. With the new liner, skimmer box and return on hand, I pumped water out removed old liner, repaired floor imperfections. Laid out the new liner and it fit the floor fine. The seams fit the floor/wall corner...

I will be installing a liner in my Esther Williams above ground, beaded 18x33x50 soon. Approximately 30” in ground, on one end and 24” on the other. The liner was ordered last month and it arrived last week. I know that I have some work to do on the pool floor because it has washouts where it...

My water has changed colors and shades of color for the past 3 weeks. Green, dark green, light green, whiteish green, light blue and now I can see the bottom but water is still not clear. It just takes TIME for the filter to do it's job when the water gets out of balance. I keep thinking it's...

One post that blocks pics is "Wierd Colored Water-Seafoam Green", posted by Fancypants in the Testing and Balancing Your Water section. Strange, by the time I typed this reply, the pic of Fancypant's pool appeared. Maybe my computer takes time to load the pics and displays the message untill then.

I'm not sure which posts they were. I have been all over this place reading for several weeks, and now that I ask why, I can't find them. Pretty sure they were in the Pumping Station somewhere. If I see it agian, I'll reply. Thanks for now.

You do not have the required permissions to view the files attached to this post. Why??

FC=21 CC=1 TC=22 PH=7.5 TA=40 will adjust in the next day or two CH= this was orange not yellow CYA=50 Ambient temp about 82 Brushing and vacuume daily Water has cleared enough to see the channels washed out under the liner. :roll: 10 year old liner gets replaced next year. I rinsed out the...

If the hose has been stepped on or kinked, it can and probably will collapse.

Snug the screws down evenly.

I would suggest plugging the lateral stand pipe, maybe wire tie a baggie over it. I don't think sand in the stand pipe is a good thing.

I would guess that there is a formula for finding the turnover rate for a given pool and it's components. But is there a way to measure the actual turnover in my pool?

I was going to hold off on changing anything till the water clears up more. Vacuuming, brushing, backflushing daily and keeping the chlorine about the same was all I was going to do, unless I'm missing something.

Thanks. I'll get the hang of this testing.