1
Latest activity Postings Media About
-
-
11poolman1 replied to the thread Heater cool down periods - what happens when the power gets cut?.New heaters do not retain anywhere near the amount of heat when shut off that older ones do/did when the recommendation was first made...
-
11poolman1 reacted to wireform's post in the thread Rust (and hole) in Combustion Chamber housing - Pentair MasterTemp 200 NA heater 200kbtu with
Like.
If you have a properly sized gas line I'd go the 399k btu. It'll use the same total amount of gas per the pool capacity to reach a gi en... -
11poolman1 replied to the thread Hayward Heater Smoking and Smelling, but working...A heater shouldn't look like that, even after years of use. If I were called out to service it, I would not put it back into service...
-
11poolman1 replied to the thread Raypak Flame Rollout around pilot.It really doesn't make a lot of difference how high they are trimmed, its the fact that there is, essentially, a high wall very close to...
-
11poolman1 replied to the thread Water leak at pump.The silicone will pull off easily. You can't seal a pressure leak from the outside with silicone. Remove the union, with Teflon tape...
-
11poolman1 replied to the thread MasterTemp 250 SFS error jumps from 330 to over 480.I've had to replace them in brand new heaters from that time period. Pentair admitted to me that they had a bad batch, even said to...
-
11poolman1 replied to the thread Poolside Tech The Attendant - anyone have experience with this?.Most service reps at the factory don't/won't tell you that their product will work with another brand's "anything" if it isn't in the...
-
11poolman1 replied to the thread Light fixture leaking? - questions.I use a clear RTV sealant like this from Home Depot (don't use it on the gasket):
-
-
11poolman1 replied to the thread Raypak Flame Rollout around pilot.A big part of the problem could be those trees surrounding the pool equipment. The overgrowth and surrounding trees won't allow the...
-
1Remove and reinstall with fresh teflon tape is always an option.
-
11poolman1 replied to the thread MasterTemp 250 SFS error jumps from 330 to over 480.How old is the heater? The SFS is a problematic part. Inexpensive to replace with aftermarket ones. Worth a try. I've used the ones from...
-
11poolman1 replied to the thread Leaking pressure gauge.Which system? Which filter? What type pool?
-
11poolman1 replied to the thread 1.5'' PVC Union thread size.Have never really paid attention to the thread-pitch on PVC parts, just know that "this" won't fit "that." Also have never seen solar...
-
11poolman1 replied to the thread Light fixture leaking? - questions.Not sure, but I always seal that area with silicone sealant when servicing a light. If water can get in, it will. There are no seams in...
-
-
Loading…
-
Loading…
-
Loading…
