Latest activity Postings Media Albums About
-
-
mknauss replied to the thread Discrepancy between cya/ fc slamming chart and poolmath recommendation.Welcome to the forum. You must save your test results entered into PoolMath. Be sure to touch the check mark in the upper right... -
mknauss replied to the thread How to make pool pump smart/work with phone?.The drive/controls are powered all the time. If you use a smart plug, you will be cycling power. It is not designed for that.
-
mknauss replied to the thread Multiple SLAM attempts.Your Taylor kit cannot measure a TA of 37 nor a CH of 47. Please post test results from your Taylor kit. Not the test strips.
-
mknauss replied to the thread Likelyhood of my Hayward pool pump being the culprit for Iron in my pool?.Sounds like iron. Your fill water has iron in it.
-
mknauss replied to the thread How to make pool pump smart/work with phone?.That pump is fully programmable on the pump. It is designed to have constant power to it. Turning the power on and off to the pumps...
-
Turns out this was related to redefining schedules as sunrise/sunset. I reset the schedule back to specific start/end time and the issue...
-
mknauss replied to the thread Likelyhood of my Hayward pool pump being the culprit for Iron in my pool?.Can you post a picture of the stains? How did you remove the stains in the past?
-
mknauss replied to the thread Hello from Ga.Welcome to the forum! I suggest you read through Pool Care Basics - Trouble Free Pool and even look at a few of our videos TFP-TV -...
-
mknauss replied to the thread Intellichlor IC40 SWG Falsely Reporting 7500 ppm salt level (true level is 3,000ppm), not outputting Chlorine, and High Salt light is flashing..What is your TA? You will not have a pH that low unless your TA is near 50ppm. If you properly keep your pH in the 7's the TA will come...
-
mknauss replied to the thread Intellichlor IC40 SWG Falsely Reporting 7500 ppm salt level (true level is 3,000ppm), not outputting Chlorine, and High Salt light is flashing..You have not told us what Taylor kit you use. I suspect you keep your TA too high, pH is thus high, and that creates scale in the SWCG...
-
mknauss replied to the thread Pool Filter makes noise.Welcome to the forum! I suspect the cartridge is vibrating in its holder. What pump do you have? Can you reduce the flow rate? I...
-
mknauss replied to the thread Black spots in concrete pool.Try a vitamin C tablet on the stain.
-
mknauss replied to the thread Intellichlor IC40 SWG Falsely Reporting 7500 ppm salt level (true level is 3,000ppm), not outputting Chlorine, and High Salt light is flashing..At 8 years the electronics may be getting tired. Mine at 9 years started to act a bit funky so I replaced it. So you doing that may...
-
mknauss replied to the thread Intellichlor IC40 SWG Falsely Reporting 7500 ppm salt level (true level is 3,000ppm), not outputting Chlorine, and High Salt light is flashing..I would do a power up of the ET with the IC cord disconnected to see if that might clear the issue. Again, that 7500 ppm number is not...
-
-
Loading…
-
Loading…
-
Loading…
-
Loading…
