Recent content by 09lancer

When we did our drain & fill I pulled out the sensor from the filter housing. I think it is a temp sensor. Anyway I replaced the gasket (larger than a hose bib gasket) & used teflon thread tape on the threads. So far my leak has not returned. Thanks for all the replies. I'm sorry I did not post...

I did pull off the insulation & found that tube goes into the filter housing. And there is a sensor on the inside of the filter housing. My owners manual doesn't tell me which sensor it is, but I guess when I drain the tub next time I can pull the sensor out to see what it does. Unless somebody...

Thanks for the reply jpg11124. I do have the sides off & found the leak. The leak is coming out of a tube that has a wire going through to what I am guessing is the dual filter housing. I think the wire leads to a sensor as the other end goes over to the control panel. I thought about gluing up...

Does anybody have an idea on what I can do to stop this leak? I am having to use a suction pump every other day to get the water out of the base of the tub. Since I can't see down there, hopefully we don't have any mildew or mold growing in that area. I sure would appreciate any tips or help.

I apologize for this late reply, but.. the heater shorted out & ruined the circuit board. Also the circulating pump was bad. All these were replaced in January. The spa repair company also gave us a new ozonator. I drained & refilled the tub so we started out with everything fresh. Everything...

Sorry for the late post. I did unhook everything from the mobo & tried plugging in items one by one to troubleshoot. It appeared to be the sensor harness as that is what tripped the breaker. I plugged everything in once again, without the sensor harness plugged in & the breaker tripped again...

PoolGuyNJ, I disconnected the ozonator & the breaker tripped. I then disconnected the heater & the breaker tripped again. If you can tell me where the HI limit switch is located I will test it & report back. Spishex, I can´t get past the circuit breaker tripping long enough to check any pumps...

Our Jacuzzi J350 is about 8 years old, is under truss on the patio & has a spa cover. The last couple of days when we checked it we have found it off & the circuit breaker tripped. When I reset the breaker the dreaded OH error code is shown. When I shut the breaker off & on again then the...

Thank you anyway for at least answering. Last night I went out to check it & found everything to be working correctly. It must have been an air lock/bubble that worked it's way out of the system. My wife will check the water tonight & if all is good, we're going in. :) Thanks again.

Hi my name is Steve (aka 09lancer). We live in sunny SW Fla in Cape Coral. We've been here 16 years now. My wife is an RN working with Hospice & I am an auto parts salesman at a new car dealership. We both work across the river in Ft Myers. This is a great site with lots of good info. We...

We bought our Jacuzzi J350 new 6 years ago & haven't had any problems until now. We have done normal routine maintenance regularly. The last drain & fill with cleaning both filters was 1 month ago. All of a sudden we had a FLO2 code & nothing worked. I researched here & other sites for ideas &...