3 HP Pump Replacement - HELP!

Jump to latest Follow Reply
D

db131

Member
Jun 10, 2021
6
NY
Hello all, I have a IntelliFlo VS-3050 pump with a screaming motor at the end of last season. I’d like to replace it.

Could you please help me with the equivalent 3hp variable speed pump that I should purchase?
The pump runs in ground pool with a connected spa hot tub.
The IntelliFlo VS-3050 pump worked great and it was an old hand me down. I’m ready to replace.
I appreciate all of your help. Looking to purchase this weekend (online I figure).

Thanks,
Dave
 
db131 said:
Could you please help me with the equivalent 3hp variable speed pump that I should purchase?
The pump runs in ground pool with a connected spa hot tub.
The IntelliFlo VS-3050 pump worked great and it was an old hand me down. I’m ready to replace.
I appreciate all of your help. Looking to purchase this weekend (online I figure).
Click to expand...
The 3050 is a very old pump, circa 2009.

The input and output dimensions are not readily available (at least for the plumbing).

1748052201307.png

I would replace with Intelliflo3 3hp, which may require some re-plumbing:
www.pentair.com

IntelliFlo3® Variable Speed & Flow Pool Pump

The award-winning, energy-efficient IntelliFlo3 VSF Pool Pump has a quiet design with sensorless flow control, app connectivity, and automation capability.
www.pentair.com www.pentair.com
 
  • Like
Reactions: Lake Placid
I "third" that recommendation. I have now had the Intelliflo 3HP VSF for 3 years and wish I had done it sooner. When you DIY, put the savings into top-notch equipment and you will never regret it.
 
Thank you all for confirming the Intelliflo3 3hp pump! Do I need anything other than the pump? I see automation controls, etc. I'm hoping the pump has a control board on it, and that is all I need. Please correct me if there is something else I need.

@PoolStored The pump connections look relatively the same. The pump might be a bit smaller or larger physically, but I plan on redoing the plumbing from my manifold to the sand filter anyway, so shouldn't be a problem. Thanks for pointing it out though!

@Jimrahbe The pump on PolyTech Pools says in store purchase only. I'm nowhere near Vegas! Will they ship?
 
db131 said:
Thank you all for confirming the Intelliflo3 3hp pump! Do I need anything other than the pump? I see automation controls, etc. I'm hoping the pump has a control board on it, and that is all I need. Please correct me if there is something else I need.

@PoolStored The pump connections look relatively the same. The pump might be a bit smaller or larger physically, but I plan on redoing the plumbing from my manifold to the sand filter anyway, so shouldn't be a problem. Thanks for pointing it out though!

@Jimrahbe The pump on PolyTech Pools says in store purchase only. I'm nowhere near Vegas! Will they ship?
Click to expand...
What automation are you currently using?
 
db131 said:
The pump on PolyTech Pools says in store purchase only.
Click to expand...
db,

If you call, they consider that an "In-house" sale, rather than an Internet sale..

Worst case, you waste a phone call.. :mrgreen:

You will have to adjust the output position, so a little plumbing will be necessary with the IntelliFlo3..

Not sure if the IntelliFlo3 comes with pump unions, but I suggest that you NEVER mount a pump without them..

Does your current pump have unions??? Show us a pic..

Thanks,

Jim R.
 

Enjoying this content?

Support TFP with a donation.

Give Support
You must log in or register to reply here.
Top Bottom
Back
Jump to latest Follow Reply