Still learning bout my pool today I have to change my salt cell, how do I turn off the water so it’s not running to the pump while I’m doing it?
Last edited by a moderator:
I have to change my salt cell, how do I turn off the water so it’s run to the pump update I’ve changed it but now the more button doesn’t work
- Thread starter mikeoliver1313
- Start date
- Jul 21, 2013
- 66,419
- Pool Size
- 35000
- Surface
- Plaster
- Chlorine
- Salt Water Generator
- SWG Type
- Pentair Intellichlor IC-60
What setting do you have on your filter MPV.
Turn your suction valve handle 180 degrees so OFF is on your pump inlet. You MUST remember to turn that back before starting your pump or you can damage things.
Turn your suction valve handle 180 degrees so OFF is on your pump inlet. You MUST remember to turn that back before starting your pump or you can damage things.
I apologize, but you’re speaking Greek to me what is a filter mpv or the suction value
- Jul 21, 2013
- 66,419
- Pool Size
- 35000
- Surface
- Plaster
- Chlorine
- Salt Water Generator
- SWG Type
- Pentair Intellichlor IC-60
MPV Valves - Further Reading
www.troublefreepool.com
Suction valve is on the intake to the pump.
Look at the handle closely and you will see OFF on one end.
Turn the handle 180 degrees to where OFF is at the green line. You may need to loosen the screw holding the handle down and pull the handle up over the stops to turn it there.
You MUST remember to turn that back before starting your pump or you can damage things.
- Jul 21, 2013
- 66,419
- Pool Size
- 35000
- Surface
- Plaster
- Chlorine
- Salt Water Generator
- SWG Type
- Pentair Intellichlor IC-60
You trying to turn the handle with the pump on or off.
Turn the pump OFF and the handle to CLOSED to block water from flowing past the filter to the SWG.
So I have i installed my new iCHLOR 30 Salt cell and every button works but the more button!!! Any ideas? I’ve tried holding it now I’ve tried just pressing it even flipping the beaker nothing
- Jul 21, 2013
- 66,419
- Pool Size
- 35000
- Surface
- Plaster
- Chlorine
- Salt Water Generator
- SWG Type
- Pentair Intellichlor IC-60
So I installed a new iCHLOR 30 and the more button doesn’t work and before I return it I just want to make sure I’m not missing anything. I did ask in a previous thread I created, asking how to turn the water supply off as well as soon as the pump turns on it just cycle through a bunch of options and gives a bunch of different numbers on the display screen eventually, it’ll stop the more button doesn’t work and I can’t increase the salt level from zero I don’t see the option to load a video, but I took one as well
