FC 13, turned down SWCG to 15% output. Had been at 20 since opening.
CyA 50, going in the right direction and adding more.
CyA 50, going in the right direction and adding more.
Got Schooled by my Taylor K-2006C - Big thanks to TFP!
- Thread starter Oli77
- Start date
Yesterday, free chlorine dove to 3! massive temps and sunshine.
Added chlorine from the bottle and raised SWCG to 30%.
Today:
FC = 6
CyA = 50, added some.
Gave it a good brushing as well.
Added chlorine from the bottle and raised SWCG to 30%.
Today:
FC = 6
CyA = 50, added some.
Gave it a good brushing as well.
Morning or evening ? 6 can make or break you depending on the time, no matter how the FC is added.
2 is much closer to the low point than 7A or 7P.
Mess around with it on a day off to find the lowest then use that time as your baseline. You don't need to test at that time once you find it, just to recognize where you are in relation to it, and allow plenty of wiggle room FC at other times.
FC 12.0
CyA 60 ppm
Warm water, in the 90s!
CyA 60 ppm
Warm water, in the 90s!
Had lots of rain for a week, NaCl was 2600 so added a good 25 lbs
FC=15
TA=80
CH=200
CyA=60
FC=15
TA=80
CH=200
CyA=60
Still up and running, although it is getting a bit colder.
FC= 12.0
CyA= 70
All good
FC= 12.0
CyA= 70
All good
Question to the experts, yesterday morning after I left for work, my wife sends me a pic of the pump/ filter area with a geyser of water spraying 5-6 feet in the air. She turned off the pump.
That evening I get home, turn the pump on full blast, no leaks. Let it run for two hours, and then turned it down to 50% output overnight. This morning, at full 100% still no leaks. So I let it run all day. Still no leaks now.
What happened yesterday morning and is there a blow valve or a pressure release valve around the top of my filter, near or on the pressure gauge maybe?
That evening I get home, turn the pump on full blast, no leaks. Let it run for two hours, and then turned it down to 50% output overnight. This morning, at full 100% still no leaks. So I let it run all day. Still no leaks now.
What happened yesterday morning and is there a blow valve or a pressure release valve around the top of my filter, near or on the pressure gauge maybe?
- Jun 24, 2021
- 15,880
- Pool Size
- 29000
- Surface
- Vinyl
- Chlorine
- Salt Water Generator
- SWG Type
- CircuPool RJ-60 Plus
Post the pic she sent…
Post pics of your pad.
What is the make and model of the filter
Post pics of your pad.
What is the make and model of the filter
The pic is very crappy but will get it. Water was spraying out of or near the top of the Hayward filter. Will take a pic of the setup during daylight and post back.
- Aug 8, 2024
- 274
- Pool Size
- 43560
- Surface
- Plaster
- Chlorine
- Salt Water Generator
- SWG Type
- Pentair Intellichlor IC-60