I have a Mastertemp heater with an Intellicenter control panel. The Mastertemp is connected to the Intellicenter though the RS485 and the bypass is connected to the Intellicenter (instead of the Mastertemp) board due to the known cooldown issues. I have the bypass valve set to the Heater circuit and I have a pump circuit set to Heater with a speed of 2050. When I set the pool to heat, the bypass valve works fine, but the pump never starts. The heater also never starts unless I turn on a pump though another method and then it works fine(which is likely the flow switch). I can't figure out why the pump will not start. I have tested this with no schedules running and with schedules running and the result is the same.
For the record, I also have a SPA that is always set to heat and use a Circuit Group to set SPA and pump speed.
For the pool I just on and off the heater since i don't want to heat all the time
For the record, I also have a SPA that is always set to heat and use a Circuit Group to set SPA and pump speed.
For the pool I just on and off the heater since i don't want to heat all the time