Mastertemp 400k and Intelliflo3 w/ I/O relay board added.

[galvinizd]

I had a new Pentair Mastertemp 400k and Intelliflo3 installed in September by Leslie's Pool and Supply. I received almost 500$ in perks. I decided to add the I/O relay board to the Intelliflo3 with the perks. They came out and installed it, (won't do that again, it was literally 2 screws snap it in, retainer screw and replace cover). They tech did not know how or couldn't install the Polaris pressure pump at this time.

I added the I/O relay board to have the pressure pump automated through the new Intelliflow pump. I also would like the Mastertemp installed onto the Intelliflow, but I'm beginning to think it is not possible. there are two configurations for the pump. a 5a and a 16a.

Has anyone else had their heater pull power through the Intelliflow to be included in the Pentair app?

Do any of you know how to connect the heater and the pressure pump to the I/O relay board on the Intelliflo3?

Thanks in advance for your input.

 

[ajw22]

The Polaris cleaner pump power can be wired through the 16A relay on the IO board.

The fireman’s switch can be connected to the 5A relay to turn the heater on/off. You will not be able to remotely control the heater temperature setting.