Hi guys! Just moved into a home with pentair easytouch/penrair IC40 system. Salt reading was showing 1950. Before adding salt, we cleaned salt cell first. Now the IC40 will not get up and running. It just continues to cycle the flashing red/green ‘low’ and ‘good” lights in an alternating fashion With solid green “flow” and sanitizer output at 80% and ”status” lights for both “cold water” and “cell” are not lit. This goes on for a couple minutes and then it is as if it tries to restart again.
I ran the diagnostics by holding the “more” button down for a few seconds and believe the cell life shows it has only used up 20%.
any ideas? Thank you in advance!
Blaine
I ran the diagnostics by holding the “more” button down for a few seconds and believe the cell life shows it has only used up 20%.
any ideas? Thank you in advance!
Blaine