Repair a bad connection

[ethany]

Somehow over time one of the low voltage connections went bad in my swg. I was told to solder this connection/ wire. Actually it’s an internal wire that gets connected to a receptacle that accepts an external banana plug that goes to salt cell.

My question is should I bypass the banana plug n solder the wire directly through, now I have a wire that can’t be disconnected if necessary or do it the right way and buy new parts for the connection? Problem is I’m not sure where to buy these parts, for that matter I’m not even sure the proper name of this receptacle/ banana plug.

Appreciate any help

 

[Bama Rambler]

I would recommend replacing it with the correct parts.
Post a picture of the old parts needed and maybe we can figure out what you need.
Mouser, Newark, etc. will have most parts.

 

[ethany]

It’s the red and blk wires

 

[Bama Rambler]

They're solder connection panel mount banana jacks.

Here are one type. Panel mount banana plugs These have metal hold down collars, but they'll work fine.

 

[ethany]

They're solder connection panel mount banana jacks.

Here are one type. Panel mount banana plugs These have metal hold down collars, but they'll work fine.

Awesome thank you. I ordered them, get them by Thursday. Yahooo!!!