I just tested, and here are my results:
pH=8.2
FC=12 drops=6ppm
CC=42 drops=1025ppm (draining soon, waiting for service to scrub scale)
TA=11 drops=110ppm
CYA=30ppm
salt (from sensor) 3500ppm
water temp: 56ºF
CSI=.86
[fill water CH=250ppm, TA=110]
draining and filling will solve the salt, CH, and CYA, and hopefully CSI. I am waiting as I find a service to clean scale from my tile.
My question is about the test kit (I'm using TF100). I've been letting the various cylinders dry before sealing up the case. Is that good, bad, or unnecessary?
Also, it seems like the pH test should be more accurate, or have a higher number range. I'm kind of off the chart. I guess I need to bring it down considerably to see the results. I guess I'm saying the test doesn't seem to me to have enough 'fidelity', if that is the right word.
Thanks
pH=8.2
FC=12 drops=6ppm
CC=42 drops=1025ppm (draining soon, waiting for service to scrub scale)
TA=11 drops=110ppm
CYA=30ppm
salt (from sensor) 3500ppm
water temp: 56ºF
CSI=.86
[fill water CH=250ppm, TA=110]
draining and filling will solve the salt, CH, and CYA, and hopefully CSI. I am waiting as I find a service to clean scale from my tile.
My question is about the test kit (I'm using TF100). I've been letting the various cylinders dry before sealing up the case. Is that good, bad, or unnecessary?
Also, it seems like the pH test should be more accurate, or have a higher number range. I'm kind of off the chart. I guess I need to bring it down considerably to see the results. I guess I'm saying the test doesn't seem to me to have enough 'fidelity', if that is the right word.
Thanks
Last edited: