Looking to get a Pentair Intellibrite 5g colored light installed during my pool remodel. What is the going price for this upgrade including install. I have a Pentair easy touch to connect to already so no need for a junction box. Thank you for your help.
Pentair LED lights installed
- Thread starter Freeway56
- Start date
blakeusa
In The Industry
It should be the cost of the light- say $500 and a couple hundred to pull the old line and install the new one. Best case.
Worst case.. the pool builder or electrician can not get the old light cord out of the conduit buried under your deck.. it could be
much more.
Are you replacing your decking?
If so make sure you install a junction box for your lights near your pool per code - then install new conduit for the light cord to the Easy touch or
tie into the existing conduit.
PS In my build we ran 100 ft conduit from the deep end to the Easy Touch. I should have had a 10 foot run to the junction box then 90 foot to the
Easy Touch.
Junction Box needs to be 8" above the pool at at least 46" awa
Pentair 78310700 Junction Box (1) 1in. and (2) 3/4in. Ports- Lexan, Black
Worst case.. the pool builder or electrician can not get the old light cord out of the conduit buried under your deck.. it could be
much more.
Are you replacing your decking?
If so make sure you install a junction box for your lights near your pool per code - then install new conduit for the light cord to the Easy touch or
tie into the existing conduit.
PS In my build we ran 100 ft conduit from the deep end to the Easy Touch. I should have had a 10 foot run to the junction box then 90 foot to the
Easy Touch.
Junction Box needs to be 8" above the pool at at least 46" awa
Pentair 78310700 Junction Box (1) 1in. and (2) 3/4in. Ports- Lexan, Black
Meadow
0
We have 2 light fixtures. One in the pool and the other in the spa. Both lights are approx 20' away from the junction box. PB is asking $1750 for the pool and $750 for the spa, Pentair Intellibrite 5g colored. This was 3 months ago during pool resurfacing.
PB will not replace the fixture if I buy the materials, bummer! I went with Pureline PureColors and DIY. I was doubtful at first because I have no experience with cable pulling but I did it.