Electrician replaced sub panel. Feed comes in from the rear. 2 hots and ground run out lower left to timer box. Hot, neutral and ground go out bottom for a 115V outlet. Issues:
1. 30 Amp dual pole breaker on left doesn't have a connecting bar. I've never seen one like this. I googled and some said it doesn't matter, the tripping occurs internally?
2. Grounds and neutrals are combined on ground bar. Wouldn't I have partial load going back to main panel on my ground wire? The bus bar is connected to my enclosure, so my enclosure is connected to Neutral. Thinking I should just take the 2 neutrals off the ground bar and use wire nut?
1. 30 Amp dual pole breaker on left doesn't have a connecting bar. I've never seen one like this. I googled and some said it doesn't matter, the tripping occurs internally?
2. Grounds and neutrals are combined on ground bar. Wouldn't I have partial load going back to main panel on my ground wire? The bus bar is connected to my enclosure, so my enclosure is connected to Neutral. Thinking I should just take the 2 neutrals off the ground bar and use wire nut?