Search results

Where I can find a replacement piece for my pool enclosure or what is would be called? It is attached in-between the vertical columns via an L shaped connector (screws)

Sorry for the delay. I left the tabs on the plaster over a year ago. The black stuff turned out to be dirt. I know because I got in the pool and it wasn't slimy and shooting it with a pressure washer quickly removed it. Unfortunately, the plaster in the area where the tabs were left is now...

Thanks, will be providing full chemistry results soon...

Also wondering if there is dirt stuck in the rough areas? Basically, wondering if this is: 1. dirt 2. gunite 3. black algae

Im more concerned about the black spots than the (probably) yellow copper staining. Do you think it is black mold or just the gunite and how would I be able to determine? The gunite would be black, right? If it is gunite showing, can I repair with some of that under water expoxy?

Just a little background. I made the dumb mistake of leaving 3" chlorine tabs on the bottom of the pool floor. The area around where the tabs were placed on the plaster surface got very rough. It is too cold to get into the pool and go under water looking but now I don't know what this is... The...

I am having a horrible time vacuuming up this white dust from dead algae. It is a 15,000 gallon in-ground pool with a Hayward 1200 cartridge filter. I bought a new filter but it gets clogged up and loses pressure within 15 minutes of being vacuumed. I have been vacuuming to waste, however, I...

My pool has been sitting without chlorine for about two months in Florida. There is a large amount of green junk which I guess is algae on the pool floor. Do I need to vacuum it to waste or I can just vacuum and keep cleaning the filter? if you vacuum to waste, do you take the filter out?

will i need to buy 8ft long roll of screen and lose a foot or will it stretch enough? edge to edge the poles in my cage are 7 feet apart, but i will need a bit more than that to get the rubber rope to lock it in.

I thought CYA never degrades and the pool has to be drained to remove it?

All tests done at waist level. Facing the sun on a clear day - 60 Facing away from the sun on a clear day - 75 In my bathroom facing the light - 90 In my bathroom away from the light - 90 Outside on a cloudy day - 90 CH - 350 if that helps.

So a week ago I found that the pool pump had tripped the breaker (not GFCI). I turned it back on and it worked fine. Now I found that the breaker was tripped again, but this time the pump will not come on at all. When I attempt to turn the pump on, the breaker is immediately tripped. The...

Thanks, I have no problem calling an electrician but I would like to educate myself about it as much as possible. Do you think most electricians are experienced and knowledgeable about pool bonding? So I would expect them to conduct testing similar to this? Swimming Pool Equipotential Bonding...

So do you think that the wire in the photo was headed underground and someone cut it off?

The heater (which does not work) has a green ground wire connected to it... that wire was connected to my old pool pump before i removed it however from there it goes nowhere or looks like it could have been cutoff if it was headed underground. And this is the pool cage with a ground...

Should I buy this? It has good reviews and is only $179.99 including shipping. Amazon.com : Harris H1572748 ProForce 1.5 HP Inground Pool Pump 115/230V : Patio, Lawn Garden This is my current pump: Hayward SP3010X15AZ Super II 1-1/2-Horsepower Pool Pump...

I can't get the impeller off of the motor. How To Replace the Motor on Your Pool Pump - INYOPools.com I am trying to use a wrench on the other side like step #32 but it is not working.

Do you think the motor was making so much noise because there is a big hole in the outer case? Or another reason? The thing was louder than a police siren.

i cant just get a new seal for the pump?

My pool pump started making an insanely loud noise and I went back there and found that there is a very big leak coming out of the bottom of the pool motor and the pool motor completely rusted through. I guess I did not do a good job of maintaining it and have barely looked at it since the...

Ran the test twice. This means there is too much chlorine in the pool? The free chlorine test, I think I had nearly 45 drops so 22ppm chlorine and zero chloramite. Cya at 40. The calcium hardness test did not turn red, only pink and then when adding drops it only turned to clear not blue...

No. The switch wasn't working. But when I wire the pump directly to the breaker it works. I think those frogs bbq'ed themselves and the timer.

The pump came back on after bypassing the timer. Can someone show me which timer I need on Lowes/Home Depot? There are a bunch to choose from and all look the same. - - - Updated - - -...