Recent content by bdearen

I think I figured it out... There are a few seals in here that are damaged.

Hello, Looking for some guidance on an issue with the pump not priming. Pool has been running fine for years until the last few weeks. Once the pump turns off, I can hear a gurgling sound at the pump and water (I think) is going back into the pool from the filter. Is the piece directly above...

Hello, I use 12.5% liquid chlorine and 31.45% muriatic acid for maintenance. I have been battling high PH and somewhat high TA for a year now and can’t get it down. I moved in about a year ago and after testing the water the CYA was so high I couldn’t measure it. The TA was 180 and PH...

The PH of my fill water is 7.6 and TA is 140. I am manually filling the pool about 2" 1x/week.

I have a spillway that I am turning on for 30 minutes per day to chlorinate the spa. We haven't used the pool much yet but with summer coming we will probably use it 1-2x/week. Good to know, so it's normal to use this amount.

Hello, I have a 20k gallon in ground gunite pool from 2006. I purchased the house about 8 months ago and drained the pool as the CYA was so high I couldn't even chart it. Everything has been going great except I am constantly battling high PH. I have tried to dose with 1 quart of acid every...

I did a ton of research here and found most people preferred Sutro however, most people on here would probably tell you to get yourself a test kit and do it manually :) Once you get the hang of that it's easy to go out 1-2x/week and do a few tests manually. I didn't want to pay the $500 up front...

I just switched out and older (2005) fiber optic light tower for 2 Jandy watercolor 24w (nichless) and it came out great. I lost the lighting in the water falls but the pool and spa is much brighter now.

Hello, Thank you all for your help. I can't believe how simple this actually was. I needed to go into the Onetouch > settings > display light > switch from "on" to "2-minute timeout" and it fixed it. So apparently that feature gets changed when switching from the old RS to iAqualink 30RS.

I have not, I didn’t know that was possible? Can you tell me which I can use?

Hello, Recently upgraded a Jandy Aqualink RS8 to an iAquaLink 3.0 iQ30-RS. Everything is working as expected however the "Onetouch" panel inside the house has a backlight that stays on permanently. Normally the backlight comes on after pressing any of the buttons and turns off after a few...

One more question on here.. Any clue where I can buy Jandy 24w LED nichless lights online? Everywhere I look says "in store only" or a comparable light for a large pool as I only have a spot for 1 nichless led?