Recent content by Allyb101

  1. A

    Epoxy Recommendations?

    THANK YOU!!
  2. A

    Epoxy Recommendations?

    Well, I am quite proud of myself! Using the tips from this site, I have located both an air leak and water leak in my pool- both have been driving me nuts and I REFUSE to call the pool company, for various reasons. The water leak is in my deep end skimmer, around the suction hole. I am going...
  3. A

    Leak at threaded connectiom

    Thank you all for talking some sense back in to me. Sigghh. I'm off to cut and repair!
  4. A

    Leak at threaded connectiom

    I have a leak at the threaded connection where the water leaves the pump box and enters the filter. We just replaced all this plumbing and obviously that connection was not done well enough. I have read that the threaded connections are the most likely to leak and that there is no way to fix it...
  5. A

    Help! I do not want to call the pool guys. Leak and liner

    Yep. Bucket test is complete. No water loss in the bucket and about an inch of water loss in the pool- overnight
  6. A

    Help! I do not want to call the pool guys. Leak and liner

    Okay, I have had it with this pool this year. It is a 20X40 in ground vinyl liner. We have fought green algae all year. Finally replaced the failing SWG- did ourselves and super proud! When we first opened the pool I noticed we were losing water faster than normal but focused on the green algae...
  7. A

    CYA not registering with test kit.....

    Nevermind! I misread.....adding cya now
  8. A

    CYA not registering with test kit.....

    Okay! Thanks. Going to do this now. Should I want to raise the cya until after the SLAM?
  9. A

    CYA not registering with test kit.....

    Okay! Still no cya registering after circulating. Add chlorine to bring to 10pmm and test after 20mimutes , got a FC reading of 4 ppm, TC .5ppm.
  10. A

    CYA not registering with test kit.....

    I need to SLAM my pool asap. After opening we found out the pump was dead. Had it replaced today and the pool is a total swamp. I check the cya level and get no turbidity ....I can see the black dot even with comparative tube is full. However I know there was some when we closed last year. I...
  11. A

    Adding DE to sand filter?

    How do I test for Cu concentration?
  12. A

    POP support- Do I stop this SLAM?

    Thanks, Richard! CC was 0.5; not 0.25ppm ( 1 drop of titrating reagent using 10mL of pool water). Yes, unfortunately I do realize that the copper is there to stay and I will probably drain some of my water before closing up this year if the sequestrant works. This is so frustrating but I am...
  13. A

    POP support- Do I stop this SLAM?

    I am not sure if I am just getting impatient or if I need to stop this SLAM. I wish I knew if this was algae, copper or both! The largest picture where you can see the debris on the bottom was pre-slam. All of that was cleaned out prior to the SLAM. The other three are from yesterday, including...
  14. image4.JPG

    image4.JPG

  15. image1.JPG

    image1.JPG