Hello everyone. I'm new to this forum and am looking for some guidance, please help! I have a container pool thats installed under ground. The mechanicals for this pool are also underground built into the container. The sump pump breaker tripped and everything was submerged underwater for about 24 hours. I'm in recovery mode trying to salvage as much as possible since everything is only 2 years old. Here's a rundown on what's working and what I'm confused about.
Everything miraculously works except for...
- The heater. It's a Pentair master temp 400k unit. When I connect it to power it trips the pool breaker, right before the breaker trips the pump flashes an error code F90052. If I leave it disconnected from power the breaker holds and the pool runs fine. What can I trouble shoot on the heater to salvage this? Do I need a whole new heater?
- Intellichem system is operational and functions aside from the acid tank pump. It wont activate when I call for acid. Replacement pump I'm guessing?
- Wifi system wont connect. Called Pentair and they suggested a new screenlogic wifi kit.
- PH reading on the PH sensor is way off. New PH sensor?
- UV system is taking power, but the light isn't on. New bulb?
Everything miraculously works except for...
- The heater. It's a Pentair master temp 400k unit. When I connect it to power it trips the pool breaker, right before the breaker trips the pump flashes an error code F90052. If I leave it disconnected from power the breaker holds and the pool runs fine. What can I trouble shoot on the heater to salvage this? Do I need a whole new heater?
- Intellichem system is operational and functions aside from the acid tank pump. It wont activate when I call for acid. Replacement pump I'm guessing?
- Wifi system wont connect. Called Pentair and they suggested a new screenlogic wifi kit.
- PH reading on the PH sensor is way off. New PH sensor?
- UV system is taking power, but the light isn't on. New bulb?