Jandy Aqualink TCX
The Jandy Aqualink TCX is a pool only control system that comes in two versions:
- Aqualink TCX for New Pools (TCXP)
- Aqualink TCX Retrofit for Intermatic Enclosures (TCXPCONV)
Both versions support one single speed pump or VS pump, heater using a 2 wire Fireman's Switch, and one JVA actuator. The TCXP version comes with a Power Center that is optional for the TCPCONV version.
The chart below from Jandy's Automation Selection Guide compares the features of Aqualink RS, Aqualink PDA, and Aqualink TCX.
If a VS pump is used then the 3HP relay is available to control a SWG, cleaner booster pump, water feature pump, or solar pump. Note that the TCX controls are powered by the same electrical feed and circuit breaker as the relay LINE power.
There are two RS-485 connector blocks and one green 10 pin connector for the low voltage heater, solar temperature sensor, water temperature sensor, and air temperature sensor.
TCX Optional Wireless Light Switch
The TCX can control an optional wireless light switch (WLS4INF). The wireless light switch replaces a standard wall mounted light switch that controls the pool lights.
Aqualink TCX Retro Fit Installation
The AquaLink TCX chassis and PIB has been designed to easily install into the Intermatic T104R and T30004R metal enclosures. The wiring is disconnected from the Intermatic T104 and the timer mechanism removed. The Aqualink TCX chassis is then slid into the box and wiring is connected to the Aqualink board.
The sensors and low voltage wiring can be connected as described above.
Bonding
The TCX power center must be connected to the pool bonding loop using 8 awg solid copper wire and copper split bolts.
