| Line 10: | Line 10: | ||
[[File:Jandy Aqualink Feature Comparison.png|thumb]] | [[File:Jandy Aqualink Feature Comparison.png|thumb]] | ||
| + | |||
| + | If a VS pump is used then the 3HP relay is available to control a SWG, cleaner booster pump, water feature pump, solar pump, or lighting. Note that the TCX controls are powered by the same electrical feed and circuit breaker as the relay LINE power. | ||
| + | |||
| + | There are two RS-485 connector blocks and one green 10 pin connector for the low voltage heater, solar temperature sensor, water temperature sensor, and air temperature sensor. | ||
Revision as of 21:01, 23 March 2024
Jandy Aqualink TCX
The Jandy Aqualink TCX is a pool only control system that comes in two versions:
- Aqualink TCX for New Pools (TCXP)
- Aqualink TCX Retrofit for Intermatic Enclosures (TCXPCONV)
Both versions support one single speed pump or VS pump, heater using a 2 wire Fireman's Switch, and one JVA actuator. The TCXP version comes with a Power Center that is optional for the TCPCONV version.
The chart below from Jandy's Automation Selection Guide compares the features of Aqualink RS, Aqualink PDA, and Aqualink TCX.
If a VS pump is used then the 3HP relay is available to control a SWG, cleaner booster pump, water feature pump, solar pump, or lighting. Note that the TCX controls are powered by the same electrical feed and circuit breaker as the relay LINE power.
There are two RS-485 connector blocks and one green 10 pin connector for the low voltage heater, solar temperature sensor, water temperature sensor, and air temperature sensor.
