Difference between revisions of "Pump Seals" - Further Reading

Line 20: Line 20:
 
==Best Quality Seals==
 
==Best Quality Seals==
 
The best seals have Viton Elastomers, a Silicon Carbide Primary Ring and a Silicon Carbide Seat.
 
The best seals have Viton Elastomers, a Silicon Carbide Primary Ring and a Silicon Carbide Seat.
 +
 +
==Seal Lubricants==
 +
 +
When installing the seal parts, using a lubricant can help. However, you want something that provides only transient lubricity. You can use a seal installation lubricant such as P-80 or [http://www.ussealmfg.com/pdfs/U.S.-SEALUBE.pdf US Sealube] or dish soap. A Hayward video suggests vegtable oil.

Revision as of 10:21, 15 April 2020

How to Apply Magic Lube II to pump basket o-ring?

  • remove the o-ring and clean it with a clean rag.[1]
  • Use the same rag to clean the channel. Not spotless, just to insure there is no grime or dirt that can cause issues.
  • Use liberal amount of pool lube, use the index finger and thumb to get a good coverage of lube on the o-ring.
  • Install o-ring and pump basket. Clean lube off hands.

The TINIEST speck of a piece of grass, leaf, etc. can cause an air leak. While you are at it, clean off the bottom lip of the plastic pump basket lid where it comes in contact with the o ring.[2]

Note: Never pull the O-ring through your fingers. Always push it through your fingers. Pulling stretches the O-ring and it ends up being too big. [3]

What are the Different Types of Pump Seals?

It's definitely worthwhile to use the "ozone/salt" seal. The regular seals will wear out and leak. The silicon carbide seals are the best, but usually too expensive to be worthwhile in most cases.[4][5]

Basic Seals

Basic seals have Buna Elastomers, a Phenolic (Plastic) Primary Ring and a Ceramic Seat. Theses are junk due to the primary ring composition.

Ozone/Salt Seals

"Ozone/salt" seals have Viton Elastomers, a Carbon Primary Ring and a Polished Ceramic Seat. These are acceptable.

Best Quality Seals

The best seals have Viton Elastomers, a Silicon Carbide Primary Ring and a Silicon Carbide Seat.

Seal Lubricants

When installing the seal parts, using a lubricant can help. However, you want something that provides only transient lubricity. You can use a seal installation lubricant such as P-80 or US Sealube or dish soap. A Hayward video suggests vegtable oil.