Hello all hope your having a good day, I have a question about my Tcell 940, my polarity and amps keep reading zero, I have voltage but no amperage. I am also getting mixed readings on my salt levels the instant salt and ave salt fluctuate quite a bit. Has anyone encountered this?
Tcell 940 problems
- Thread starter chrisflood
- Start date
- May 3, 2007
- 16,954
- Pool Size
- 20000
- Surface
- Plaster
- Chlorine
- Salt Water Generator
- SWG Type
- Hayward Aqua Rite (T-15)
Welcome to the forum!
Which SWG controller do you have?
What is the SWG % setting?
SWGs have a duty cycle set by the SWG % setting so there are periods of time where the unit is shut off and will read 0 amps but it is dependent on which controller you have. Also, with most of the controllers, they allow you to restart the cycle so you can see the SWG operating to make sure everything is working ok. But again, the procedure to do this is dependent on the controller model.
www.troublefreepool.com
www.troublefreepool.com
Which SWG controller do you have?
What is the SWG % setting?
SWGs have a duty cycle set by the SWG % setting so there are periods of time where the unit is shut off and will read 0 amps but it is dependent on which controller you have. Also, with most of the controllers, they allow you to restart the cycle so you can see the SWG operating to make sure everything is working ok. But again, the procedure to do this is dependent on the controller model.
Read This BEFORE You Post
We'd like to give you a few basic pointers of items that will help us, help you. From filling out a signature to posting test results.
www.troublefreepool.com
Create Your Signature - Further Reading
www.troublefreepool.com