I had a new SWG and VS pump installed last month. The installer hooked it up so that when I throw the circuit breaker the SWG controller and pump are powered on. The pump has its own timer so I can program it to run whenever but the controller remains on al the time. I need to push a button on it to turn on the cell. The only way the cell turns off is when the pump is not running as the controller has a low flow cuttoff function or I have to manually push the button on the Controller again to turn the cell off. I questioned the installer if it was OK to operate the system this is way and he responded that all of the installation he has done operate this way. Is this an acceptable situation or should there be a timer that powers the SWG controller on and off?