Salt cell turn off after 30-40 minutes

[johnhugo]

The box was made in July 2005.

Try putting the hump down if the cell is mounted horizontally.

Try increasing the flow if it is running a a slow flow rate.

Maybe it is getting time for a new automation system. The hump is mounted in the down position. The pump is running at 2950 RPM. Is that enough? Thanks

 

[JamesW]

The pump is running at 2950 RPM. Is that enough?

That should be fine.

Go to the diagnostic screen, note the readings and then press the + button to reverse the polarity.

When the new numbers appear, see what they are.

Then, press + again and note the new readings.

Report ALL readings.

 

[johnhugo]

The box was made in July 2005.

Try putting the hump down if the cell is mounted horizontally.

Try increasing the flow if it is running a a slow flow rate.

The salt cell is mounted in that position. It is clean. The pump rate is 2950. Is that enough? Thanks

 

[JamesW]

The salt cell is mounted in that position. It is clean. The pump rate is 2950. Is that enough? Thanks

That should be fine.

Go to the diagnostic screen, note the readings and then press the + button to reverse the polarity.

When the new numbers appear, see what they are.

Then, press + again and note the new readings.

Report ALL readings.

 

[johnhugo]

That should be fine.

Go to the diagnostic screen, note the readings and then press the + button to reverse the polarity.

When the new numbers appear, see what they are.

Then, press + again and note the new readings.

Report ALL readings.

When I changed polarity it takes about 10 seconds for the readings to settle. I did it four times

-25.8v, -6.4a, 3200ppm
+26.0v, +6.1a, 3100 ppm
-25.8v, -6.4a, 3300 ppm
+26.0v, +6.0a, 3000 ppm

Pool Temp was 74

 

[JamesW]

Everything looks like it is working properly.

 

[johnhugo]

Everything looks like it is working properly.

Thanks for all of your help. If anything odd happens, I will let you know.