Running 2 Speed Pump in Low Speed

[JDunks]

I have a Jandy Aqualinks system that is connected to a two speed pump. When in normal mode the pump runs in high speed. When the spillover for the spa is running the pump runs in low speed. I would like to have my two speed pump default to running in low speed when it turns on since I don't need it for vacuuming the pool out. My question is how do I accomplish this? I have included a picture of my setup with the panel off.

 

[gkw4815]

In your Aqualink program, your low speed timing should be a "subset" of your filter pump timing. Ie your filter pump should be "on" whenever your pump is running at any speed, your low speed should be "on" whenever your pump is running at low speed. Example from my system (pump runs on high speed from 545-6, normal speed from 6-7 and 2-4, low speed from 7-2 and 4-midnight):

 

[1poolman1]

Start with a 5-minute high-speed run to be sure the pump primes, then have it switch to low speed. You can have several programs, just be sure they don't overlap.

 

[JDunks]

I dont have the iaqualink. My system is old school.

 

[1poolman1]

I dont have the iaqualink. My system is old school.

Just set the programs in the "program" menu, either the "One Touch" or "All Button" indoor control. You can download an RS manual if you don't have one.