RJ-45/60 install location

[Sn00py]

I never go under 1800-1900 rpm, running pump 9Pm-5pm...Do you think I should I still rotate the cell? I do have room.

 

[Rancho Cost-a-Lotta]

The instruction manual recommends it. If not, keep an eye on the cell and watch for a gas bubble forming on top.

 

[Sn00py]

will just rotate it then and be done with it

 

[Sn00py]

will ask here

RJ60 reads salt level 2950ppm after 8h run, Tayler kit 3600. Should I add more salt or leave it as is?

 

[Ahultin]

will ask here

RJ60 reads salt level 2950ppm after 8h run, Tayler kit 3600. Should I add more salt or leave it as is?

Let it ride 24 hours

 

[Sn00py]

Let it ride 24 hours

After that if it’s still showing lower than Taylor test should I add more salt or leave it?

 

[mas985]

It is far easier to add salt than it is to remove it. So I would wait several days before making that decision and even then, unless the SWG is complaining about low salt, I would leave it alone.

 

[Ahultin]

After that if it’s still showing lower than Taylor test should I add more salt or leave it?

unless you are experiencing an issue, if the SWG is happy, everyone is happy! My ic40 has a significantly different reading than my taylor.

 

[Sn00py]

Thank you!