Replacing microcontroller on Pro Logic board

Aquatica

Platinum Supporter
LifeTime Supporter
Jun 26, 2010
514
Nassau, Bahamas
is it possible or do we have to purchase a whole new board?

Thanks. btw we are getting Hi salt/amp error. water temp is 89F, we just installed a new cell and salt level is 2,200ppm so must be the microcontroller.
 

JasonLion

TFP Expert
Platinum Supporter
LifeTime Supporter
May 7, 2007
37,880
Silver Spring, MD
Did you configure the cell type on the control unit? The older units didn't require that, but the newer ones require that you configure the cell type correctly or you get strange error messages.
 

JasonLion

TFP Expert
Platinum Supporter
LifeTime Supporter
May 7, 2007
37,880
Silver Spring, MD
While it is possible to replace a micro controller in theory, doing so in practice requires special equipment and a fair bit of precision work. Unless you know someone who does that and has the right tools, it is easier to replace the entire board.
 

Aquatica

Platinum Supporter
LifeTime Supporter
Jun 26, 2010
514
Nassau, Bahamas
Thanks Jason. Do you know where I can purchase just the board? I see the control box but really only need the board.