- Jul 14, 2019
- 28
- Pool Size
- 12500
- Surface
- Fiberglass
- Chlorine
- Salt Water Generator
- SWG Type
- Pentair Intellichlor IC-20
Opened pool on May 4th. Pics of that are here;
www.troublefreepool.com
FC: 0, CC: 0, PH: 7.3, TA: 40, CH: 300, CYA: 0, Salt: 1400
Started SLAM on May 5th and keep up w/ it best I can but work and travel gets in the way. No one else here to maintain, unfortunately. Pool clear by the 9th but can't check levels due to travel. Pool temps are low to mid 70s.
Turned on my heater May 17th and set to 85. On May 20th I get what appears to be black algae (pics below) but it is stuff I cannot gather up well to verify on a paper sheet. Been scrubbing w/ SS brush since this time and raise FC levels. to hold between high recommended level and SLAM. I just picked the 1/2 way point as a target. My salt gen is currently off.
Doesn't seem to be clearing up and my work schedule right now is such that I can't be here monitoring it all the time. Still chewing thru FC at a high rate even though the water is very clear. FC at 630pm yesterday was 21. FC this morning at 650am was 16.5. So a loss of 4.5 overnite.
All numbers at 630pm yesterday and water is very clear. I was in the pool yesterday scrubbing all surfaces, even removing drain grates and cleaning in there.
FC: 21.0, CC: 0.5, PH: 8.0, TA: 125, CH: 500, CYA: 75
Should I attempt to keep the high FC for longer or just move to a SLAM? I'm off till Tuesday for the holiday and can spend some time monitoring and adjusting.
Thanks.
Let’s see your water after removing winter cover!! *PICS THREAD*
Are they expensive? Do you think it’s worth the extra cost? I’m also wondering if most leave their solar covers on while the pump is off? Or does it not matter? I may need to make a separate post about all my solar cover questions, LOL! I have not priced above ground pool reels so I wouldn't...

FC: 0, CC: 0, PH: 7.3, TA: 40, CH: 300, CYA: 0, Salt: 1400
Started SLAM on May 5th and keep up w/ it best I can but work and travel gets in the way. No one else here to maintain, unfortunately. Pool clear by the 9th but can't check levels due to travel. Pool temps are low to mid 70s.
Turned on my heater May 17th and set to 85. On May 20th I get what appears to be black algae (pics below) but it is stuff I cannot gather up well to verify on a paper sheet. Been scrubbing w/ SS brush since this time and raise FC levels. to hold between high recommended level and SLAM. I just picked the 1/2 way point as a target. My salt gen is currently off.
Doesn't seem to be clearing up and my work schedule right now is such that I can't be here monitoring it all the time. Still chewing thru FC at a high rate even though the water is very clear. FC at 630pm yesterday was 21. FC this morning at 650am was 16.5. So a loss of 4.5 overnite.
All numbers at 630pm yesterday and water is very clear. I was in the pool yesterday scrubbing all surfaces, even removing drain grates and cleaning in there.
FC: 21.0, CC: 0.5, PH: 8.0, TA: 125, CH: 500, CYA: 75
Should I attempt to keep the high FC for longer or just move to a SLAM? I'm off till Tuesday for the holiday and can spend some time monitoring and adjusting.
Thanks.
Attachments
Last edited: