Raypak RP2100 Flame rollout issue

Jump to latest Follow Reply
swamprat69 said:
Continuity of the ignition cable is from the rod (electrode/sparker) to the connector at the other and of the ignition cable. Continuity of the ground wire is from the pronged pilot hood to case ground with the pilot assembly in place.
Click to expand...
Ok thank you that makes sense. I’m going to remove the igniter module control box and test it with my multimeter. I feel like that has to be it since I have two motherboards (one new). I don’t think the module is sensing flame and then sending the 24v to MV.
 
swamprat69 said:
Continuity of the ignition cable is from the rod (electrode/sparker) to the connector at the other and of the ignition cable. Continuity of the ground wire is from the pronged pilot hood to case ground with the pilot assembly in place.
Click to expand...
Ok thank you that makes sense. I’m going to remove the igniter module control box and test it with my multimeter. I feel like that has to be it since I have two motherboards (one new). I don’t think the module is sensing flame and then sending the 24v to MV.
 
You must log in or register to reply here.
Thread Status
Hello , This thread has been inactive for over 60 days. New postings here are unlikely to be seen or responded to by other members. For better visibility, consider Starting A New Thread.
Top Bottom
Back
Jump to latest Follow Reply