Been thinking about how I'm running my pump, SWG, floor cleaners and skimmer. If you note my sig, I have an EasyTouch panel and QuickTouch 4 remote (as well as an Autelis WiFi controller). Currently I have only two programs (circuits?) set up, a low speed (1600rpm) for the skimmer and a high speed (2300 rpm) for the floor cleaner. I run the SWG through the floor cleaner and thus, run the cleaner twice per day about 2-3 hours each cycle to get an appropriate amount of Cl generated (holding 5 ppm Cl). I also run the skimmer program once between the floor cleaner cycles about 2-3 hours per day. Am I doing this wrong? Should I be running the SWG with my skimmer cycle and increasing it to 4-6 hrs/day and drop the floor cleaner to once per day about 2 hours?
I believe I know how to make this swap. I simply flip the switch on the back of my diverter actuator to power the SWG when the skimmer is running versus when the floor cleaner is running. Am I correct?
Should I have more circuits set up to allow for multiple speeds for either the skimmer or floor cleaner? Thinking that I can reduce my electricity use by a bunch if I'm not running the pump at 2300 rpm (800 watts!) for 4-6 hours/day.
Any opinions and reasoning would be greatly appreciated. Only been doing it this way for 6+ years!
I believe I know how to make this swap. I simply flip the switch on the back of my diverter actuator to power the SWG when the skimmer is running versus when the floor cleaner is running. Am I correct?
Should I have more circuits set up to allow for multiple speeds for either the skimmer or floor cleaner? Thinking that I can reduce my electricity use by a bunch if I'm not running the pump at 2300 rpm (800 watts!) for 4-6 hours/day.
Any opinions and reasoning would be greatly appreciated. Only been doing it this way for 6+ years!