Pool blaster not working well

[Joelle Pelland]

Hi, I was hoping someone could help me with this: when I start the vacuum and put it in the water it works well for a few minutes then it stops. After taking out the water I push the start button twice. The first time nothing happens and the second time it starts again. It will lasts a few seconds under the water and stops again. This goes on and on. Any idea what could be causing this?
Thanks for your help

 

[Rocket J Squirrel]

How long have you had this Pool Blaster? If it's new, you should be able to have it repaired or replaced under warranty. If it's old, perhaps you can pay a repair shop to fix it. Or it may be heading for Pool Blaster Heaven.

 

[Joelle Pelland]

How long have you had this Pool Blaster? If it's new, you should be able to have it repaired or replaced under warranty. If it's old, perhaps you can pay a repair shop to fix it. Or it may be heading for Pool Blaster Heaven.

I would say up to 2 years now. It’s our second one and in my opinion they last no longer than 2 years. Thanks for the tip

 

[Harshman]

I would say up to 2 years now. It’s our second one and in my opinion they last no longer than 2 years. Thanks for the tip

Must be the battery life then. It may be replaceable.

 

[Rocket J Squirrel]

Well, mine just started exhibiting similar behavior. It shuts off after 5-10 minutes of use and will not turn on again until it has sat for a few hours. Doesn't seem like a battery issue because it does come back to life after a while. I think it's reached end of life.

 

[Rocket J Squirrel]

I found my problem. The plastic near the red power button is broken, allowing water inside the unit. I had to look pretty closely to see the small break. The Blaster doesn't turn on at all any more. New one on order.