Opening my pool for the first time this year. When turning it on for the first time only 2 of the 3 jets had water coming from them. My pool knowledge is extremely low, so I am not sure what the issue might be.
I followed a step by step process on opening, but can't figure out where I went wrong. All caps were removed. Should I have both valves set to open (I know in the picture I uploaded both are not open)? When water was first pushed out of the two jets, it was with very high pressure/bubbles.
I followed a step by step process on opening, but can't figure out where I went wrong. All caps were removed. Should I have both valves set to open (I know in the picture I uploaded both are not open)? When water was first pushed out of the two jets, it was with very high pressure/bubbles.
