Ok... What's the secret to getting a Group Circuit to appear?

[Mark McLeroy]

I am 99% away from fully recovering from my lightning strike. All the hardware is fully functional again. I just can't get the dam Intellicenter app or web portal to do 1 thing. I am trying assign 1 button on my 4 button spa side remote a group circuit I created. The circuit name is Air Blower. When it turned on, the spa air blower comes on, and the Intelliflo pump increases speed (to a feature speed circuit I created). However when I go to the button assignment in both the app and the web portal the circuit doesn't show in the list. Another group circuit shows but not this one. The portal fought me on creating the group circuit. It didn't allow me to add circuits so I had to create it in the app.
Any suggestions would be much appreciated.

 

[Texas Splash]

This question is a bit out of my normal pool world. Perhaps @ajw22 might know?

 

[ajw22]

I have not played around with Group Circuits.

It sounds like one of the many glitches in the IntelliCenter software.

Did you try and define it using the Outdoor Control Panel? The hard wired control panel seems to be the most reliable when the app or browser software cannot make something work or stick.

I have an Indoor Control Panel wired to my IntelliCenter that I find very convenient.

 

[Mark McLeroy]

I have not played around with Group Circuits.

It sounds like one of the many glitches in the IntelliCenter software.

Did you try and define it using the Outdoor Control Panel? The hard wired control panel seems to be the most reliable when the app or browser software cannot make something work or stick.

I have an Indoor Control Panel wired to my IntelliCenter that I find very convenient.

It seems like I was kinda over thinking this. Instead of running a group of features. I just created a waterfall feature and that actuated the intelllivalve. Then I added the Waterfall feature to the list of speed in the intelliflo circuit and all worked well.