Noob to the forum. Looking for CYA advice

For curiosity sake because loss doesn't always decrease as the process plays out, but what was the FC target and how long ago did you add ?
 
Clean your test vial...rubbing alcohol and dry it. Try it again.
Also, what are the dimension of your pool? L/W shallow D and deep D?
Also, next time you add, wait 30 minutes and test FC, report that too.
 
Last edited:
Clean your test vial...rubbing alcohol and dry it. Try it again.
Also, what are the dimension of your pool? L/W shallow D and deep D?
Also, next time you add, wait 30 minutes and test FC, report that too.
Fc 12.5, CC 1.5
I think i should just continue testing it and see if the fc drops in a couple hours. What di you think?
 

Enjoying this content?

Support TFP with a donation.

Give Support
Sorry, missed on the ramp. Likely 23K. Start there, then use either an acid addition (later not in slam) or chlorine addition and test 30 minutes after an addition and see if you got the correct result. If still too high, lower pool volume 500, if too low raise pool volume 500.

Pick one place and use that place for all your testing to be consistent. If shallow is lower FC then choose shallow.

1747183712717.png