First-time poster, long-time reader/follower.
I’ve read all the posts on Nature2 and MPS in this and other forums. These helped me enormously to figure out what worked best in my situation. Thanks to all the people who post here! There’s debate on the effectiveness/usefulness of the Nature2 setup, but in my case, I had very few options as I am very sensitive to chlorine. Thankfully, I found a method that works well. I thought I would give back to this community my recipe for tub maintenance. I hope it helps others who need/want to avoid chlorine as much as possible and are having trouble figuring out Nature2 and MPS. That said, this is only what works for me given my setup and usage. This will not necessarily work for you!
HOT TUB MAINTENANCE - LOW CHLORINE RECIPE - NATURE2/MPS/OZONE
Start up procedure:
I’ve read all the posts on Nature2 and MPS in this and other forums. These helped me enormously to figure out what worked best in my situation. Thanks to all the people who post here! There’s debate on the effectiveness/usefulness of the Nature2 setup, but in my case, I had very few options as I am very sensitive to chlorine. Thankfully, I found a method that works well. I thought I would give back to this community my recipe for tub maintenance. I hope it helps others who need/want to avoid chlorine as much as possible and are having trouble figuring out Nature2 and MPS. That said, this is only what works for me given my setup and usage. This will not necessarily work for you!
HOT TUB MAINTENANCE - LOW CHLORINE RECIPE - NATURE2/MPS/OZONE
Start up procedure:
- Fill spa (1000 L) with water using hose filter and install clean tub filter
- Add 2 cups Borax (50ppm) gradually, 1/2 cup at a time, run jets for 20 mins each 1/2 cup dose
- Once water reaches 80 F, balance total alkalinity between 80 to 120
- Wait a while and balance ph 7.2 to 7.8
- Install a new Nature2 stick
- Add 2.5 tbsp of dichlor to activate Nature2 and run jets for 20 mins
- Add 2 tbsp of MPS shock, run jets for 20 mins
- Wait until chlorine levels dissipate before use (~48 hrs)
- Test water with test strips/kit, if you like, to make sure nothing is totally out of balance
- Add 1 tbsp of MPS shock before and 1 tbsp MPS after each soak, run jets for 20 mins. Note: if not used daily, dose with 1 tbsp MPS and 1 tbsp dichlor about every 3-5 days
- Check and rinse filter
- Thoroughly test water (Taylor K-2106 kit), adjust as needed
- Add 4 tbsp MPS, run jets for 20 min
- Add 2.5 tbsp dichlor, or 250ml (1 cup) bleach, run jets for 20 min. Wait for chlorine to dissipate before use (~24 hrs).
- Install clean filter
- Follow weekly procedure
- Clean dirty filter and soak for 24h in 1/2 jug vinegar, 4 tbsp TSP and 1 tbsp dishwasher detergent
- Run spa with pipe cleaner, without filter, no aeration, cover off for 1 hour
- Drain tub
- Wipe down with vinegar
- Follow start-up procedure
- Replace ozone generator check valve
- Dispose of both filters and start new set of filters