Almost 3 weeks on vacation and came back to pool that is clear. The pH was high at 9.0 but I expected that as my pH is always increasing.
The FC also dropped from 5.2 to 2.8 even though SWG was set to 55. I had expected it to hold steady or be slightly higher than when I left. The only difference in my usual maintenance was I dropped pump RPM down to 1250 and ran 24 hours while I was gone, I did this in case power went out and mechanical timer got out of sync with my regular pump hours. So perhaps the lower flow reduces the efficiency of the salt generation? Something I'll keep an eye on.
Otherwise just a little dirt due to storms that hit while away, so other than adding acid to drop the pH I just need to get my vacuum running to clean the bottom.
Results before/after vacation:
FC 5.2/2.6
CC 0.0/0.0
pH 7.6/9.0
TA 80/80
CH 350/350
CYA 70/70
Temp 78/78
Sent from my LG-H830 using Tapatalk
The FC also dropped from 5.2 to 2.8 even though SWG was set to 55. I had expected it to hold steady or be slightly higher than when I left. The only difference in my usual maintenance was I dropped pump RPM down to 1250 and ran 24 hours while I was gone, I did this in case power went out and mechanical timer got out of sync with my regular pump hours. So perhaps the lower flow reduces the efficiency of the salt generation? Something I'll keep an eye on.
Otherwise just a little dirt due to storms that hit while away, so other than adding acid to drop the pH I just need to get my vacuum running to clean the bottom.
Results before/after vacation:
FC 5.2/2.6
CC 0.0/0.0
pH 7.6/9.0
TA 80/80
CH 350/350
CYA 70/70
Temp 78/78
Sent from my LG-H830 using Tapatalk