Hi All!
So after successfully battling an algea problem I was going to vaccum up the dead algea but accidently did it while my sand filter was on backwash setting
When I was done I switched it to rinse and ran it for about 45 second. Now it's running in filter mode again. What should I do now????
Water is crystal clear and all chemicals are correct.
Thanks in advance for any guidance.
-FM
So after successfully battling an algea problem I was going to vaccum up the dead algea but accidently did it while my sand filter was on backwash setting
When I was done I switched it to rinse and ran it for about 45 second. Now it's running in filter mode again. What should I do now????
Water is crystal clear and all chemicals are correct.
Thanks in advance for any guidance.
-FM