Linking Blower to spa circuit.

[JsVil]

Hi everyone,

I am using Easytouch 8.
I currently have a blower which uses a schedule and an egg timer and I was creative enough to add a switch that gets activated when the valve turns for the spa function to get the bubbles. This takes away two spots on my schedule and I would like to free them.

Is there a way to connect the blower own the panel.so it turns on with the spa circuit?

Thanks in advance.

 

[Rocket J Squirrel]

If you have an unused relay, you can power the blower from it. Disconnect it from its unused Aux relay output and connect it to the spa mode output instead.

 

[JsVil]

If you have an unused relay, you can power the blower from it. Disconnect it from its unused Aux relay output and connect it to the spa mode output instead.
View attachment 536458

Hi there !

Thanks for your response. where exactly is that connector? I don't see it on the motherboard

 

[JsVil]

Hi there !

Thanks for your response. where exactly is that connector? I don't see it on the motherboard

I see these ones...

 

[Rocket J Squirrel]

The output labeled J7 matches the spa output in the diagram.

 

[JsVil]

I see these ones...

I just figure it out ! Thank you so much ! Now the blower comes on when spa is turned on and off in the same way