Intelliconnect with Superflo VS

[ReneeMezera]

I have a SuperfloVST and just hooked it up. It works. Set program 1 on the pump to zero and 24 hrs. Connect the 485 to the pump and the screen will start blinking auto and 0. It’s ready for the home app.

Oh my goodness, we are so frustrated. Our pool was just installed, we have the Superflo VST, Intelliconnect, RS485, updated firmware but cannot get this to work We are going to reset my home app, disconnect the 485, and try this tomorrow. Fingers crossed

 

[jklocke]

Welcome to TFP.

This thread has good instructions for getting the Intelliconnect and Superflo VST working together - WhisperFlo VS and intelliconnect

First step is to make sure that the Pentair Home app is talking to the Intelliconnect. Once that is working, power everything off and then connect the RS-485 to the pump and Intelliconnect and power everything back on. Follow the instructions below and hopefully everything will start working.

I'm guessing your pool builder isn't much help? Have you reached out to Pentair for any assistance?