Installation issue

[strauss]

I just finished installing my 27' round pool.
I have been filling it for the past 2 day and I am close to done.
I just noticed the that there is a spot, which range from 3 of my upright columns that are too low. Like a slight dip.
Is there any solution to this at this point?
I was wondering if something like a mud jacking service could raise the columns.
I installed all the upright columns on patio block that I recessed into the ground.
I was not packed dirt, so I don't think it sunk.

 

[Casey]

The only way to fix non level post is to start over. Once the pool is full, you will really notice the difference in the post. Do you have pictures you can share so we can see what you're seeing?