I have an Jandy RS8 with iaqualink and it will not change off of spa mode. I completely erased all schedules and this did not fix it. After this wouldn't work, I flipped all breakers killing all power to the board. When I kill power my JVAS move to pool mode. but as soon as the power is restored the valves move to spa mode. Then I did a "clear memory" and it did nothing but cleared all of my memory. When I go to service mode everything works as it should. Is there anyone out there with any ideas, I'm struggling here and I have been banging my head on the wall too much. Anything will help!
IAQUALINK RS8 HELP!! Stuck in spa mode
- Thread starter somethingfunny
- Start date
So when you cleared the memory, did you reset everything to the desired settings? If so, it could be the valve itself?
Does the iAqualink actually say it is in Spa Mode status, or the valves are just moving to open the spa side while it still lists Pool Mode status?
- Jun 7, 2017
- 9,181
- Pool Size
- 29000
- Surface
- Plaster
- Chlorine
- Salt Water Generator
- SWG Type
- Jandy Aquapure 1400
It could be as simple as the JVA switch on the bottom of the switch being set to the opposite side it should be. Flip it the other way to test.
PROBLEM SOLVED! The Spa link is bad and is forcing spa mode. Once I unplugged it from the board, my problems Instantly went away. Thank you everyone for the responses!