Hello just joined the forum. I have a 6 month old iAquaLink and Intelliflo vsf 3hp.
What I would like to do is turn on the spa & spa heat, but not a spa speed. Something like 2300 rpm rather than 3200, so that I minimize electrical spend while I am waiting for spa to get up to temp.
I have a One touch "Hot Tub" setup for the normal spa operation (3200).
It seems that I can only control 1 speed using spa One Touch. iAqua tech support confirmed that only a schedule can control speeds, or I can have 1 spa speed. If I want a different speed I need to manually go in and change spa speed in VSP... that is not gonna work for me.
So i figured out a workaround.... almost. I added an additional One Touch called "Warm tub", with a slower vsp setting.
If I press "Hot Tub", wait a few minuted then press "warm tub" the speed will reduce to 2300rpm.... but it only holds that speed for exactly 20 minutes. I looked for a setting in iAqua that is set for 20minutes and could not find anything.
Does anyone have any suggests to try that I may be overlooking? Could this be something that is set on the Intelliflo motor controller that is overriding iAqualink?
Thanks,
Lancerif
What I would like to do is turn on the spa & spa heat, but not a spa speed. Something like 2300 rpm rather than 3200, so that I minimize electrical spend while I am waiting for spa to get up to temp.
I have a One touch "Hot Tub" setup for the normal spa operation (3200).
It seems that I can only control 1 speed using spa One Touch. iAqua tech support confirmed that only a schedule can control speeds, or I can have 1 spa speed. If I want a different speed I need to manually go in and change spa speed in VSP... that is not gonna work for me.
So i figured out a workaround.... almost. I added an additional One Touch called "Warm tub", with a slower vsp setting.
If I press "Hot Tub", wait a few minuted then press "warm tub" the speed will reduce to 2300rpm.... but it only holds that speed for exactly 20 minutes. I looked for a setting in iAqua that is set for 20minutes and could not find anything.
Does anyone have any suggests to try that I may be overlooking? Could this be something that is set on the Intelliflo motor controller that is overriding iAqualink?
Thanks,
Lancerif
Last edited: