Hello all,
I recently purchased a Pentair 1.5hp Superflo VS pump to replace an old single stage and I also have the Pentair Solartouch controller. I've ran into a problem that some others on here have experienced as well with the appropriate speed being triggered when solar heat is demanded. I purchased the External Control Wiring Kit (Pentair P/N 353129Z) and I am not certain exactly where to wire it within the Solartouch. I've read a few posts concerning this but I couldn't find a definite resolution. Should I wire the red and green (speed 1 for my application) to the solar pump relay terminals? Which wire, red or green goes where or does it matter?
Thanks for any and all help.
I recently purchased a Pentair 1.5hp Superflo VS pump to replace an old single stage and I also have the Pentair Solartouch controller. I've ran into a problem that some others on here have experienced as well with the appropriate speed being triggered when solar heat is demanded. I purchased the External Control Wiring Kit (Pentair P/N 353129Z) and I am not certain exactly where to wire it within the Solartouch. I've read a few posts concerning this but I couldn't find a definite resolution. Should I wire the red and green (speed 1 for my application) to the solar pump relay terminals? Which wire, red or green goes where or does it matter?
Thanks for any and all help.