Hi All. First time poster. I am helping my brother in law winterize his pool and his plumbing setup is much different than mine. In the attached photos can you take a look and see how I could best blow out these lines? I have a cyclone blower but not sure where to plug into. My setup has a port where I can connect into. Thanks in advance for your help!!
Help needed on how to blow out lines
- Thread starter sandyman720
- Start date
- May 23, 2015
- 24,472
- Pool Size
- 16000
- Surface
- Plaster
- Chlorine
- Salt Water Generator
- SWG Type
- Pentair Intellichlor IC-60
Uncouple the tablet feeder from the return pipe and the filter and blow out the return lines from there. Uncouple the pump, move it and blow out the suction lines. Drain the filter. Move indoors whatever equipment you don’t want out in the elements. If you add antifreeze to the lines, do so after the plugs are sealed up in the pool and then plug and cap off all the PVC lines at the pad.
You just helped me SO much! Thank you!!!! (I know this is an older post, but found it searching!)