I found this forum while searching out information about replacing my old Janky Aqualink control board. It is a PCB 81245A with two wired remotes , 4 wired valves. The system has one filter and two pumps. It is all connected to an inground pool and a seperate spa. One of the pumps is a newer Pentair VSP while the other is an older Hayward. This is my first pool so at 76 I have been facing a steep learning curve. This forum has been helpful so far. Thanks.
HELLO!
- Thread starter tomeyates
- Start date
Hey T and Welcome !!!
If you haven't found them yet, hereyago : Pool Care Basics
Be sure to post a thread over in the equipment section. Our automation experts may or may not see your question over here.
If you haven't found them yet, hereyago : Pool Care Basics
Be sure to post a thread over in the equipment section. Our automation experts may or may not see your question over here.
- Jun 22, 2014
- 47,873
- Pool Size
- 17888
- Surface
- Fiberglass
- Chlorine
- Salt Water Generator
- SWG Type
- CircuPool RJ-45 Plus
- Jun 24, 2021
- 7,510
- Pool Size
- 30000
- Surface
- Vinyl
- Chlorine
- Salt Water Generator
- SWG Type
- CircuPool RJ-60
