~1 year lurker, big fan of the community and the wealth of knowledge here! We have a smallish (for Texas, 13,000 gal) pool, 1.5 years old, all Hayward equipment, no spa, it all ties nicely into our Omni Logic controller. I used a neighborhood pool guy last week to put in a heater (picked a Hayward 250k gas unit, so it would play nicely with the controller and other equipment, theoretically). He is a Pentair guy, and I did not specify in the request for service that they tie the unit into the controller. they didn't come out for a site visit prior to install. I felt price overall was quite fair for purchase and hookup of heater (included running 55 feet of gas line from the meter to the heater, regulator, check valve, shutoff valves, etc). Anyway, it's all in, works manually, I just need to run some low voltage wiring from the heater to the Omni unit 3 feet away so that I can monitor/control from my phone remotely. I'm reasonably handy, seems like an easy wire-up, but I can't figure out if there's Hayward wire harness I need to buy? Lots of videos out there on hooking up "at the heater", 2 wire or 3 wire, but not sure if they are using Home Depot 22 gauge general wire? The input to the Omni Logic box looks like it needs a specific connection, just not sure where to get that or if it's just an easy add. Hope this makes sense, thanks for any guidance!
Last edited:
