My DE filter sprang a leak last night and I lost about 2 feet of water before I saw the leak on the DE filter at the clamp. I replaced the o-ring about 6-weeks ago and noticed that it was slightly too large and am now attributing the issue to that. I picked up a replacement 0-ring and cleaned the heck out of the clasp and area but when I put the brand new o-ring on noticed that it's still seemingly an inch too big. I would say it's loose fitting and it I tighten one side of the o-ring the spillage is noticeable. Is this normal? If so, how am I supposed to get a good seal so this won't happen again? I'll try to attach pictures. I have the Pentair FNS60 and I bought the o-ring aligned to product #39010200
Of course, I'm in the middle of this right now so any quick guidance would be appreciated. Thanks!
Of course, I'm in the middle of this right now so any quick guidance would be appreciated. Thanks!
